DOCUMENT:Q72169 04-FEB-2002 [msdos] TITLE :MS-DOS 5 README.TXT: Documentation Corrections and ... PRODUCT :Microsoft Disk Operating System PROD/VER::5.0 OPER/SYS: KEYWORDS: ====================================================================== ------------------------------------------------------------------------------- The information in this article applies to: - Microsoft MS-DOS operating system version 5.0 ------------------------------------------------------------------------------- SUMMARY ======= The following information was taken from the Microsoft MS-DOS 5 README.TXT file. This is the packaged product of MS-DOS version 5.0 that is licensed to OEMs (original equipment manufacturers). MORE INFORMATION ================ 8. DOCUMENTATION CORRECTIONS AND ADDITIONS ------------------------------------------ 8.1 New CV.COM for CodeView: Users of CodeView versions 3.0 to 3.13 should use the program CV.COM to start CodeView. For more details, see the section on CodeView in the file APPNOTES.TXT. 8.2 Documentation Corrections: The following are corrections to the "Microsoft MS-DOS User's Guide and Reference": COMP /? Help: Online help for the COMP command /d switch should state that the default format is hexadecimal. EXPAND Command: The example in Chapter 4 of the "Microsoft MS-DOS Getting Started" guide refers to the wrong installation and upgrade disks. The disk referred to as Disk 1 should be Disk 2; the disk referred to as Disk 2 should be Disk 3. FORMAT Command: If you can't use the FORMAT command to format an unformatted disk, try using the /u switch. MIRROR Command: You cannot use the MIRROR command with a network drive or any drive you created by using the ASSIGN, SUBST, or JOIN command. UNDELETE Command: Do not use the UNDELETE command in the following circumstances: - When other programs are active. - With the LOAD= command or the SHIFT+ENTER key combination in Windows. - With Task Swapper in MS-DOS Shell. UNFORMAT Command: The UNFORMAT /p switch is not compatible with the /j switch. 8.3 Hercules Display Adapter (MSHERC.COM): If you use MS-DOS Editor or QBasic with a Hercules display adapter, run MSHERC.COM before you run either program. 8.4 QBasic "On Error" Command: Online help for Microsoft QBasic incorrectly states that ON ERROR RESUME NEXT is a valid statement. The correct syntax is as follows: ON ERROR GOTO 8.5 SMARTDrive and Third-Party Partitions: If your system includes a third-party disk partition and you try to use SMARTDrive, you may receive a message stating that you cannot load SMARTDrive. You can force SMARTDrive to load by specifying the /p switch. However, doing so may corrupt your hard disk if either of the following conditions is true: - Your hard disk contains more than 1024 cylinders. - Your hard disk is not supported by the system's ROM BIOS. If you have partitions created by using third-party disk-partitioning software, use SMARTDrive ONLY if you are sure your hard disk contains 1024 or fewer cylinders AND it is supported directly by the system's ROM BIOS. Additional query words: 5.00 ====================================================================== Keywords : Technology : kbMSDOSSearch kbMSDOS500 Version : :5.0 ============================================================================= THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY. Copyright Microsoft Corporation 2002.