DOCUMENT:Q79538  17-DEC-2000  [msdos]
TITLE   :360K Floppies Used in 1.2 MB Drive May Be Unreadable
PRODUCT :Microsoft Disk Operating System
PROD/VER:MS-DOS:3.x,4.x,5.x,6.0,6.2,6.21,6.22
OPER/SYS:
KEYWORDS:

======================================================================
-------------------------------------------------------------------------------
The information in this article applies to:

 - Microsoft MS-DOS operating system versions 3.1, 3.2, 3.21, 3.3, 3.3a, 4.0, 4.01, 5.0, 5.0a, 6.0, 6.2, 6.21, 6.22 
-------------------------------------------------------------------------------

SUMMARY
=======

Double-sided, double-density 5.25-inch (360K) disks, when formatted in a 360K
drive and then written to on a high density 5.25-inch (1.2 MB) drive, may no
longer be readable in the 360K drive.

Conversely, disks formatted as 360K in a 1.2 MB drive and then written to in a
360K drive may no longer be readable in the 1.2 MB drive.

MORE INFORMATION
================

360K disk drives write a relatively wide track at 40 tracks per inch. 1.2 MB
drives normally write at 80 tracks per inch, and therefore write a somewhat
narrower data track. This renders the use of 360K disk interchangeably between
the two drives as a less than reliable means of exchanging data, because the
result can be a narrow data track superimposed upon a wide data track, or vice
versa.

There are two methods to increase the reliability of disk data transfer between
these two drive types:

Method 1
--------

To transfer data from a 1.2 MB drive to a 360K drive using a 360K disk, do the
following:

1. Start with a blank, unformatted 360K disk. In the 1.2 MB drive, format the
   disk using the /4 or /f:360 option, as follows:

      format x: /4

   or, for MS-DOS version 4.0 or later,

      format x: /f:360

   (where "x" is the 1.2 MB drive designator, and assuming the MS-DOS directory
   is in the path).

   This will allow the format of the 360K media in the 1.2 MB drive.

2. Perform reads and writes on the media while in the 1.2 MB drive, but perform
   ONLY reads from the disk while in the 360K drive. Writing to the media in the
   360K drive may render it unreadable.

Method 2
--------

To transfer data from a 360K drive to a 1.2 MB drive using 360K media, do the
following:

1. Start with a blank, unformatted 360K disk. Format the disk as normal in the
   360K drive.

2. Perform reads and writes on the disk while in the 360K drive, but perform
   ONLY reads from the media while in the 1.2 MB drive. Writing to the media in
   the 1.2 MB drive may render it unreadable.

For more information on the FORMAT command, consult your MS-DOS manual.

Additional query words: 6.22 3.0 3.00 3.1 3.10 3.2 3.20 3.21 3.22 3.3 3.30 3.3a 3.30a 4.0 4.00 4.0a 4.00a 4.01 4.01a 5.00 5.00a 6.00 6.20

======================================================================
Keywords          :  
Technology        : kbMSDOSSearch kbMSDOS321 kbMSDOS400 kbMSDOS320 kbMSDOS330a kbMSDOS621 kbMSDOS622 kbMSDOS620 kbMSDOS600 kbMSDOS310 kbMSDOS500 kbMSDOS330 kbMSDOS401 kbMSDOS500a
Version           : MS-DOS:3.x,4.x,5.x,6.0,6.2,6.21,6.22

=============================================================================

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS
PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND.  MICROSOFT DISCLAIMS
ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES
OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE.  IN NO
EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR
ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL,
CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF
MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE
POSSIBILITY OF SUCH DAMAGES.  SOME STATES DO NOT ALLOW THE EXCLUSION
OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES
SO THE FOREGOING LIMITATION MAY NOT APPLY.

Copyright Microsoft Corporation 2000.