DOCUMENT:Q96331  22-NOV-1999  [msdos]
TITLE   :Stacker Err Msg: WARNING: Unrecognized Load High...
PRODUCT :Microsoft Disk Operating System
PROD/VER:MS-DOS:6.0,6.2,6.21,6.22
OPER/SYS:
KEYWORDS:

======================================================================
-------------------------------------------------------------------------------
The information in this article applies to:

 - Microsoft MS-DOS operating system versions 6.0, 6.2, 6.21, 6.22 
-------------------------------------------------------------------------------

SYMPTOMS
========

After you upgrade to MS-DOS 6.x, you may receive the following message if you
are using Stacker:

   WARNING: Unrecognized load high method. Unable to verify driver fit

The driver loads successfully, but you must press a key to continue.

CAUSE
=====

This message occurs if you use a DEVICEHIGH= command for the Stacker device
drivers in your CONFIG.SYS file. It does not occur if you use a DEVICE= command.

WORKAROUND
==========

To work around this problem, ensure the command for SETVER.EXE is located above
the Stacker device drivers in the CONFIG.SYS file. To do this, SETVER.EXE must
be located on the uncompressed Stacker partition.

1. Copy SETVER.EXE to the uncompressed drive. For example, if your compressed
   drive is C and the swap drive is D, copy SETVER.EXE to drive D as follows:

      copy c:\dos\setver.exe d:\ 

2. Put the following SETVER.EXE statement at the top of your CONFIG.SYS file:

      device=c:\setver.exe

3. Restart your computer.

The product included here is manufactured by a vendor independent of Microsoft;
we make no warranty, implied or otherwise, regarding this product's performance
or reliability.

Additional query words: 6.22 6.00 6.20 2.0 2.1 2.x 3rdparty

======================================================================
Keywords          :  
Technology        : kbMSDOSSearch kbMSDOS621 kbMSDOS622 kbMSDOS620 kbMSDOS600
Version           : MS-DOS:6.0,6.2,6.21,6.22

=============================================================================

THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS
PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND.  MICROSOFT DISCLAIMS
ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES
OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE.  IN NO
EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR
ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL,
CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF
MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE
POSSIBILITY OF SUCH DAMAGES.  SOME STATES DO NOT ALLOW THE EXCLUSION
OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES
SO THE FOREGOING LIMITATION MAY NOT APPLY.

Copyright Microsoft Corporation 1999.