DOCUMENT:Q165059 09-FEB-2000 [exchange] TITLE :XCON: Exchange Does Not Support Maximum 3-digit Country Codes PRODUCT :Microsoft Exchange PROD/VER:winnt:4.0,5.0,5.5 OPER/SYS: KEYWORDS:kbusage exc4 exc5 exc55 ====================================================================== ------------------------------------------------------------------------------- The information in this article applies to: - Microsoft Exchange Server, versions 4.0, 5.0, 5.5 ------------------------------------------------------------------------------- SYMPTOMS ======== If a route is set up on a Microsoft Exchange Server connector for type X.400 and it uses the three-digit numeric string for the country code, messages sent out that route will return a non-delivery report (NDR) to the message originator as follows: Your message did not reach some or all of the intended recipients. Subject: Test Numeric Country Code Sent: 2/27/97 11:17:12 AM The following recipient(s) could not be reached: 'TEST (Numeric)' on 2/27/97 11:19:13 AM Unable to deliver the message due to a recipient problem MSEXCH:MSExchangeIS:MORFSITE2:MIRALPHA1 CAUSE ===== According to Recommendation X.402 section 18.3.3 of the 1988 ITU Blue Book, it is valid to use the numeric country codes specified in Recommendation X.121 on the C= portion of an X.400 address. Microsoft Exchange Server does not currently support this format. Exchange Server does fully support ISO 3166, which mandates the use of two-character printed strings for country codes. STATUS ====== Microsoft has confirmed this to be a problem in Microsoft Exchange Server versions 4.0 and 5.0. We are researching this problem and will post new information here in the Microsoft Knowledge Base as it becomes available. Additional query words: x400 ====================================================================== Keywords : kbusage exc4 exc5 exc55 Technology : kbExchangeSearch kbExchange500 kbExchange550 kbExchange400 kbZNotKeyword2 Version : winnt:4.0,5.0,5.5 Issue type : kbbug ============================================================================= THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY. Copyright Microsoft Corporation 2000.