XCON: NT Event ID 51

Last reviewed: December 9, 1997
Article ID: Q166308

The information in this article applies to:

  • Microsoft Exchange Server version 4.0

SYMPTOMS

A Windows NT event ID 51 appears in the event log on a computer running Microsoft Exchange Server with configured X.400 connectors.

   3/7/97 8:23:42 PM
   MSExchangeMTA
   Warning Security  51
   N/A
   <Exchange_server_name> An unknown MTA has attempted to bind. The MTA
   name in bind is <other_mta_host>. The MTA presentation address is
   /n:0x636166656F6C65, Association index: 2354. [MTA XFER-IN 23 42] (14)

CAUSE

A remote message transfer agent (MTA) has attempted to establish a messaging session with the computer running Exchange Server and there has been a mismatch in the specified security information. The security information for the computer running Exchange Server is specified on the remote MTA name or Password fields, the T, S and P selector in the Outgoing and Incoming OSI address information, and the local MTA name or password fields on the Override tab of the Exchange connector. Improper entry of any one or a combination of these results in a security violation.

The Remote and the Local password fields are case-sensitive and must be an exact match with the information submitted by the adjacent MTA when it attempts to connect (bind). The T, S and P Selector may be entered in either hexadecimal or text; verify that only the required fields are specified and that the required fields are specified in the correct format. If multiple X.400 connectors use a given transport stack to connect to foreign X.400 MTAs, verify that each of the connectors has a unique value specified for the T Selector (TSAP). The T Selector specifies the entry point to the transport layer of the protocol and as such should be unique.

MORE INFORMATION

Remote MTA name and password fields on the General tab and the Open Sytems Interconnect (OSI) information for Outgoing and Incoming OSI address information are on the Stack tab of the X.400 connector configuration dialog box. P Selector (PSAP) is not supported in 1984 mode. S Selector (SSAP) is not supported in 1988 X.410 mode. T Selector (TSAP) is the most uniformly used throughout X.400 MTAs.


Additional query words: X400
Keywords : XCON kbtshoot kbusage
Version : WinNT:4.0
Platform : winnt


THE INFORMATION PROVIDED IN THE MICROSOFT KNOWLEDGE BASE IS PROVIDED "AS IS" WITHOUT WARRANTY OF ANY KIND. MICROSOFT DISCLAIMS ALL WARRANTIES, EITHER EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IN NO EVENT SHALL MICROSOFT CORPORATION OR ITS SUPPLIERS BE LIABLE FOR ANY DAMAGES WHATSOEVER INCLUDING DIRECT, INDIRECT, INCIDENTAL, CONSEQUENTIAL, LOSS OF BUSINESS PROFITS OR SPECIAL DAMAGES, EVEN IF MICROSOFT CORPORATION OR ITS SUPPLIERS HAVE BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF LIABILITY FOR CONSEQUENTIAL OR INCIDENTAL DAMAGES SO THE FOREGOING LIMITATION MAY NOT APPLY.

Last reviewed: December 9, 1997
© 1998 Microsoft Corporation. All rights reserved. Terms of Use.